.:HSTuners::

94_AcCoRd_EX · 07-12-2002, 06:44 PM

Well, I have a PrecisionPower PC250 amp sitting around now since I haven't purchased any highs for the front of my car. The cheap Sony amp that is pushing my cheap freebie bazooka tubes is going out on me, so I'm going to put this amp in its place for now.

I have no manual for it, and PPI doesn't have any online documentation for the PC series, only the PCX. I know the tubes won't take much power, but this amp only does 50x2 @ 4 ohms stereo.

Can I bridge the amp and wire the subs in parallel to get a 4 ohm mono load to drive the subs? Is this done by using the L+ and R- terminals like on the PCX series?

Any help you can give me would help a lot. Thanks guys

07-12-2002, 06:44 PM	#1
94_AcCoRd_EX Insomniac Moderator Join Date: Aug 2001 Location: OR Age: 44 Posts: 11,142	Help with wiring options... Well, I have a PrecisionPower PC250 amp sitting around now since I haven't purchased any highs for the front of my car. The cheap Sony amp that is pushing my cheap freebie bazooka tubes is going out on me, so I'm going to put this amp in its place for now. I have no manual for it, and PPI doesn't have any online documentation for the PC series, only the PCX. I know the tubes won't take much power, but this amp only does 50x2 @ 4 ohms stereo. Can I bridge the amp and wire the subs in parallel to get a 4 ohm mono load to drive the subs? Is this done by using the L+ and R- terminals like on the PCX series? Any help you can give me would help a lot. Thanks guys __________________ 1994 Accord EX coupe --Need hosting for your pics on HST? PM me...--

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode