.:HSTuners::

blind34_1 · 11-09-2002, 05:56 PM

I wouldn't put them on your parking or headlights. Cops don't like these too well, so you should wire in a switch for them.

you won't like those things. They are made out of very cheap plastic and break after a month.

You have two wires a washer led right? Heres what you do:

1. mount them

2. zip tie the wires through your hood, so they are out of the way.

3. pop through your firewall plug. Usually its on the passenger side. its rubber. remove it

4. run the wires through. you may have to bend out ahanger and stick it through and tape the wires on the pull themn through.

5. get some solderless connectors and wire.

6. look at the wires you ran in. two of them prolly have a stripe on it. the other is prolly black. the striped ones are your positive wires. the black ones go to ground.

7. splice the two grounds together and the two positves together. splice to their respective wires. run the now single ground wire to some bare metal onyour chassis.

8. run the now single postive wire to where you want your switch. connect the one wire to the switch.

9. take another wire and run it from you cig lighter (its easiest) to the other terminal of the switch.

your done.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

11-09-2002, 05:56 PM	#1
blind34_1 Registered User Join Date: May 2002 Location: IL Age: 41 Posts: 1,813	I wouldn't put them on your parking or headlights. Cops don't like these too well, so you should wire in a switch for them. you won't like those things. They are made out of very cheap plastic and break after a month. You have two wires a washer led right? Heres what you do: 1. mount them 2. zip tie the wires through your hood, so they are out of the way. 3. pop through your firewall plug. Usually its on the passenger side. its rubber. remove it 4. run the wires through. you may have to bend out ahanger and stick it through and tape the wires on the pull themn through. 5. get some solderless connectors and wire. 6. look at the wires you ran in. two of them prolly have a stripe on it. the other is prolly black. the striped ones are your positive wires. the black ones go to ground. 7. splice the two grounds together and the two positves together. splice to their respective wires. run the now single ground wire to some bare metal onyour chassis. 8. run the now single postive wire to where you want your switch. connect the one wire to the switch. 9. take another wire and run it from you cig lighter (its easiest) to the other terminal of the switch. your done.