.:HSTuners::

09-04-2001, 05:54 PM

Damn on a 5th gen... All i have to say is Just take everything apart one by one.. Once u get to the part where ur actually at the gauges.. slide the faces under the needle (Bend it a little) Then glue it on carefully.. Make sure you get the part near the center of the needle (where it rotates) And use a fork to lift up the needles too so it can have more clearance with the Gauge face (or it will get stuck sometimes which is very annoying!)
GOOD LUCK!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

09-04-2001, 05:54 PM	#2
VN-Tec Posts: n/a	Damn on a 5th gen... All i have to say is Just take everything apart one by one.. Once u get to the part where ur actually at the gauges.. slide the faces under the needle (Bend it a little) Then glue it on carefully.. Make sure you get the part near the center of the needle (where it rotates) And use a fork to lift up the needles too so it can have more clearance with the Gauge face (or it will get stuck sometimes which is very annoying!) GOOD LUCK!