.:HSTuners::

Accord Man · 01-20-2002, 04:35 PM

This might seem overkill..

But here's what I did once..

I soldered an allen key into the stripped slot. It worked fine..

I was even able to melt the soldering stuff off the key, so I didnt even have to waste that..

You could do that, or instead of soldering, use some type of mad ass strong adhesive..

Contact cement or a strong epoxy should be up to the task!!

Hope the sun starts to shine on you soon!

01-20-2002, 04:35 PM	#1
Accord Man THE GENERAL Join Date: Aug 2001 Location: Earth (usually) Age: 43 Posts: 5,698	This might seem overkill.. But here's what I did once.. I soldered an allen key into the stripped slot. It worked fine.. I was even able to melt the soldering stuff off the key, so I didnt even have to waste that.. You could do that, or instead of soldering, use some type of mad ass strong adhesive.. Contact cement or a strong epoxy should be up to the task!! Hope the sun starts to shine on you soon! __________________ HondaStyle.com Babysitter's Club Member #0 Soon to be >Dr Max Immuh<

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode