.:HSTuners::

V8killimports · 04-02-2004, 04:23 PM

I been looking at doing some sheetmetel tools and other stuff.. but screw that, I am just gonna mock up what I want to fabricate with foamboard, take measurements, then use this tool to make it. That box above priced with 304 stainless steel cost $140 to make. Not sure how accurate that is.. and it's not final at all anyways.. that took me all of 3 minutes to design, but better than any of the crap I have tried to fabricate thus far.

04-02-2004, 04:23 PM	#1
V8killimports Registered User Join Date: Sep 2002 Location: Beale AFB, CA Posts: 1,377	Re: Re: emachineshop.com!! I been looking at doing some sheetmetel tools and other stuff.. but screw that, I am just gonna mock up what I want to fabricate with foamboard, take measurements, then use this tool to make it. That box above priced with 304 stainless steel cost $140 to make. Not sure how accurate that is.. and it's not final at all anyways.. that took me all of 3 minutes to design, but better than any of the crap I have tried to fabricate thus far.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode