.:HSTuners::

03-22-2004, 11:58 AM

You don't need to take the needles off, it slides over the needles. However, make sure the gauges don't impeed the movement of the needles.

Just push them all the way to the right and make sure the needle goes back to the pin smoothly.

And just hook them to one of your headlight fuses.

Did you get my email on all this?

And did ya figure the shift knob too?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-22-2004, 11:58 AM	#12
SolPol Posts: n/a	You don't need to take the needles off, it slides over the needles. However, make sure the gauges don't impeed the movement of the needles. Just push them all the way to the right and make sure the needle goes back to the pin smoothly. And just hook them to one of your headlight fuses. Did you get my email on all this? And did ya figure the shift knob too?