.:HSTuners::

09-10-2001, 07:47 PM

I looked at the article, but it says nothing about the monuts. The drivers side is H shaped tubular. One side of the H is in the original mount position, a bar connects it to the other side of the H which is connected to the motor. The rear mount is the same design only bigger.

They don't look too hard to fabricate - just make sure the welds are super strong and the steel is solid and not hollow.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

09-10-2001, 07:47 PM	#6
Wookie Posts: n/a	I looked at the article, but it says nothing about the monuts. The drivers side is H shaped tubular. One side of the H is in the original mount position, a bar connects it to the other side of the H which is connected to the motor. The rear mount is the same design only bigger. They don't look too hard to fabricate - just make sure the welds are super strong and the steel is solid and not hollow.