.:HSTuners::

2ndGenTeg · 05-08-2003, 03:12 PM

Is that a thin head gasket? 10.6 is a low CR, considering this setup. Also, why spend the money for Toda and Spoon, but get Skunk2 camshafts? Are the cylinder walls reinforced at all? Which header?

As it sits, this motor would have been much better had it just been a B18C build. With the money spent, it could have been bored out and run Jun or Toda camshafts to a pretty decent redline. Regardless, I'm still interested to see dyno results from this motor.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

05-08-2003, 03:12 PM	#1
2ndGenTeg 4th Gear Join Date: Aug 2001 Location: Boulder, CO Age: 45 Posts: 830	Is that a thin head gasket? 10.6 is a low CR, considering this setup. Also, why spend the money for Toda and Spoon, but get Skunk2 camshafts? Are the cylinder walls reinforced at all? Which header? As it sits, this motor would have been much better had it just been a B18C build. With the money spent, it could have been bored out and run Jun or Toda camshafts to a pretty decent redline. Regardless, I'm still interested to see dyno results from this motor.