.:HSTuners::

04-19-2003, 02:11 AM

your best bet with a T3/T4 depending on the trim is to go with a full tubular equal length manifold with a mounting flange for a Tial 35mm waste gate. I'm not sure what you are looking for power wise but i would definitely reccomend getting it jet hot coated and or wrapping the header. depending on the trim you may need all the heat you can get

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

04-19-2003, 02:11 AM	#5
HndaTch627 Posts: n/a	your best bet with a T3/T4 depending on the trim is to go with a full tubular equal length manifold with a mounting flange for a Tial 35mm waste gate. I'm not sure what you are looking for power wise but i would definitely reccomend getting it jet hot coated and or wrapping the header. depending on the trim you may need all the heat you can get