.:HSTuners::

12-14-2002, 11:00 PM

Well, I did them today, new Brembos and honda pads, piece of cake, for everyone intrested, you dont have to have your bearing pressed out unless you are wanting to replace it. Hardest part is getting all the parts unrusted

but while I was in there, I cleaned the crap out of everything, looks sharp now, now for some new tires and some KYB AGX's.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

12-14-2002, 11:00 PM	#4
-=DFOX=- Posts: n/a	Well, I did them today, new Brembos and honda pads, piece of cake, for everyone intrested, you dont have to have your bearing pressed out unless you are wanting to replace it. Hardest part is getting all the parts unrusted but while I was in there, I cleaned the crap out of everything, looks sharp now, now for some new tires and some KYB AGX's.