Help with wiring options...
 

Well, I have a PrecisionPower PC250 amp sitting around now since I haven't purchased any highs for the front of my car. The cheap Sony amp that is pushing my cheap freebie bazooka tubes is going out on me, so I'm going to put this amp in its place for now.

I have no manual for it, and PPI doesn't have any online documentation for the PC series, only the PCX. I know the tubes won't take much power, but this amp only does 50x2 @ 4 ohms stereo.

Can I bridge the amp and wire the subs in parallel to get a 4 ohm mono load to drive the subs? Is this done by using the L+ and R- terminals like on the PCX series?

Any help you can give me would help a lot. Thanks guys :cool:

Anyone? :crazy: I'm going on vacation soon (long roadtrip) and I need to get this working. :)

i think it should workthe way you said it. why don't you go to a audio shop and ask them.

Its a 1-1.5 hour drive to the nearest shop because I'm living on the coast right now. :no:

gotta move to a city country boy ;) jfwy

:D :D I do during the school year. :cool:

What ohm load do the bazookas carry?
J

I was assuming 4, but I'll go check tomorrow. :o