.:HSTuners::

ewaugh · 02-18-2006, 10:50 PM

After blowing a transmission I ended up with a ZC transmission to replace it. The only problem with that is there are very few axle's that will work with this trans. So, if anyone has a Drivers side ZC axle laying around, or know anyone that does, let me know. the_evan at earthlink . net.

ewaugh

*pdiggitydogg* · 02-20-2006, 03:57 PM

http://www.enginereplacement.com/htd...vic_crx_zc.htm

Quote:

If you are useing your stock transmission or any other US L3 transmission your stock axles will work. For Japanese ZC transmissions use ZC intermediate shaft and two right hand axles from your model car with 90-93 Integra inner joints. 90-93 Integra axles can be modified to work also. If your car is either a CRX HF, or Civic Standard model you will also need to replace the knuckles and hubs from any other Civic or CRX model to use the modified 90-93 Integra axles.

Ever thought about using the OG tranny?

02-18-2006, 10:50 PM	#1
ewaugh Registered User Join Date: Jun 2004 Location: AL Posts: 86	Zc After blowing a transmission I ended up with a ZC transmission to replace it. The only problem with that is there are very few axle's that will work with this trans. So, if anyone has a Drivers side ZC axle laying around, or know anyone that does, let me know. the_evan at earthlink . net. ewaugh __________________ "Drive Carefully: 90% of all people are caused by accidents"

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode