.:HSTuners::

*Whtehnda93DXSdn* · 03-27-2002, 10:55 PM

youcould see if you can find out the spots of the rub..ie taking the rim off and looking for the points of contact. it idt can be seen then cut that area of the fender lining to accomodate. if it's the lip of the fender take you a dremel and cut notches all the way down then take a rubber mallet and tap it flush w/ the fender..

the bat method to roll a fender can be costly in the form of a new fender...

Hope this might help.....

03-27-2002, 10:55 PM	#4
Whtehnda93DXSdn It has 4 Doors... Join Date: Nov 2001 Location: Fredericksburg,Va Age: 50 Posts: 907	youcould see if you can find out the spots of the rub..ie taking the rim off and looking for the points of contact. it idt can be seen then cut that area of the fender lining to accomodate. if it's the lip of the fender take you a dremel and cut notches all the way down then take a rubber mallet and tap it flush w/ the fender.. the bat method to roll a fender can be costly in the form of a new fender... Hope this might help..... __________________ Another good forum site: Tuners Alliance

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode