.:HSTuners::

03-22-2002, 12:11 AM

This is a good question and josh is right unless you crossover to more agressive cams like I did and up your compression to 11.5:1 a stock ecu will be fine anything that needs to be changed with bolt on can be satisfied with an aftermarket FPR. But when I replaced all my internals I bought a Apexi Vafc which allowed me to remap my entire fuel curve for both high and low lobes and allowed me to adjust my vtec engagment point and gives a little heads up about whats going on inside your car.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-22-2002, 12:11 AM	#3
Saint212 Posts: n/a	This is a good question and josh is right unless you crossover to more agressive cams like I did and up your compression to 11.5:1 a stock ecu will be fine anything that needs to be changed with bolt on can be satisfied with an aftermarket FPR. But when I replaced all my internals I bought a Apexi Vafc which allowed me to remap my entire fuel curve for both high and low lobes and allowed me to adjust my vtec engagment point and gives a little heads up about whats going on inside your car.