.:HSTuners::

thermal · 04-13-2006, 05:26 PM

It has been super slow on progress. All I have done to my Teg is install an AEM 5 BAR MAP sensor. I think that I also figured out why my car wont idle normal. The Boomslang conversion harness I have didnt have the pinout installed for the IACV solenoid. I'm talking about they didnt even have the pins in the connectors. So, I ran an external wire and repin the proper connector to control the Ford IACV. However, I still havent had a chance to test it out since my tuner has to reconfigure my MAP settings to compensate for a 5 BAR.

I have been busy doing other people's car. I'm also trying to make money on the side. This week, starting Friday, I will be installing an S2000 muffler on a 2001 civic, then fabricate/weld intercooler piping for an Eclipse, then possibly fab a 2.5 inch DP on a CRX.

More to come...........

04-13-2006, 05:26 PM	#9
thermal Banning Machine Join Date: Aug 2001 Location: My Garage, Va. Posts: 5,547	It has been super slow on progress. All I have done to my Teg is install an AEM 5 BAR MAP sensor. I think that I also figured out why my car wont idle normal. The Boomslang conversion harness I have didnt have the pinout installed for the IACV solenoid. I'm talking about they didnt even have the pins in the connectors. So, I ran an external wire and repin the proper connector to control the Ford IACV. However, I still havent had a chance to test it out since my tuner has to reconfigure my MAP settings to compensate for a 5 BAR. I have been busy doing other people's car. I'm also trying to make money on the side. This week, starting Friday, I will be installing an S2000 muffler on a 2001 civic, then fabricate/weld intercooler piping for an Eclipse, then possibly fab a 2.5 inch DP on a CRX. More to come........... __________________ Project Teg Visit the Turbo Forum

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode