.:HSTuners::::Hondas Wanted:: |
10-07-2005, 10:03 PM | #1 |
1st Gear
Join Date: Apr 2005
Location: el paso tx
Age: 44
Posts: 36
|
Help on prepping d16 for boost
I'm strengthening the bottom end of a d16 sohc vtec with Ls rods to withstand a good amount of boost. However i also was thinking of doing a port and polish on the head and 3 angle valve job and getting a turbo cam shaft. I'm not sure if i should go that route because of the compression ratio. I know i need to lower compression to be able to boost higher without blowing the motor. Should i just forget the port and polish and just get the cam or quite the opposite? Will it increase compression or lower it? Can someone help me out?
|
Thread Tools | |
Display Modes | |
|
|