.:HSTuners::

blind34_1 · 06-28-2005, 07:22 PM

any corrosion on terminal? how about the wire? I had a heck of a time trying to figure out why my car wouldn't start all the time. The primary wire was corroded, not allowing enough current to flow. A quick fix was to go at it with sand paper. A real fix was to cut back to non corroded wire, and crimp on a new terminal. Then use that anti-corrosion grease.

If your problem is not a corroded wire, next I would check the fuse box under the hood, not just the under-the-dash one.

check the ground wire for corrosion as well.

After that....test the starter?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

06-28-2005, 07:22 PM	#5
blind34_1 Registered User Join Date: May 2002 Location: IL Age: 41 Posts: 1,813	any corrosion on terminal? how about the wire? I had a heck of a time trying to figure out why my car wouldn't start all the time. The primary wire was corroded, not allowing enough current to flow. A quick fix was to go at it with sand paper. A real fix was to cut back to non corroded wire, and crimp on a new terminal. Then use that anti-corrosion grease. If your problem is not a corroded wire, next I would check the fuse box under the hood, not just the under-the-dash one. check the ground wire for corrosion as well. After that....test the starter?