.:HSTuners::

10-03-2003, 08:10 AM

Ok , thanks fellas. My current setup now is a B16 swap boosted and I'm using a Haltech ECU. Can I just swap in the Type R and use my current setup eg. axels,shiftlinkage,motor mounts. Also are the plugs on the motor the same as the ones on the USDM B16 , Also I know the compression ratio on the type R is about 11:1 ratio can I get away with just a head gasket to reduce the compression so I can boost it.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-03-2003, 08:10 AM	#7
turbodx Posts: n/a	Ok , thanks fellas. My current setup now is a B16 swap boosted and I'm using a Haltech ECU. Can I just swap in the Type R and use my current setup eg. axels,shiftlinkage,motor mounts. Also are the plugs on the motor the same as the ones on the USDM B16 , Also I know the compression ratio on the type R is about 11:1 ratio can I get away with just a head gasket to reduce the compression so I can boost it.