.:HSTuners::::Hondas Wanted:: |
12-15-2004, 02:57 PM | #1 |
Registered User
Join Date: Nov 2002
Location: Santa Barbara, California
Age: 38
Posts: 5,446
|
f22 and h22/23 compatibility
so I'm curious would a h23 or h22 intake manifold fit a f22b1 and if it does do you think there would be any benefits to it?
I was talking to Chris about this and i tried searching but I was unable to gather much useful information also what other parts off a h23/22 would fit the f22? |
12-20-2004, 08:44 AM | #2 |
THE GENERAL
Join Date: Aug 2001
Location: Earth (usually)
Age: 42
Posts: 5,698
|
Not sure of the fit..
But you wouldnt gain anything from it.. A few years ago I went and spent a ridiculous amount of money on machining the inside of my manif.. which was ok, but not worth what it cost. If my car was making 300+ hp, then it would have been insanely beneficial..
__________________
HondaStyle.com Babysitter's Club Member #0 Soon to be >Dr Max Immuh< |
12-20-2004, 08:47 AM | #3 |
THE GENERAL
Join Date: Aug 2001
Location: Earth (usually)
Age: 42
Posts: 5,698
|
PS, after the job the engine was smoother throughout the powerband (idle-->6-7k).. And the higher end was noticeably stronger.
__________________
HondaStyle.com Babysitter's Club Member #0 Soon to be >Dr Max Immuh< |
12-23-2004, 12:15 AM | #4 |
Registered User
Join Date: Apr 2002
Location: Winnipeg, MB
Age: 40
Posts: 3,821
|
how much did it cost exactly^^
|
01-17-2005, 10:04 PM | #5 |
3rd Gear
Join Date: Jan 2003
Location: columbus,ms
Age: 41
Posts: 393
|
the manifolds of the f and h series will swap. there are some sites selling the euro r intake manifold for both series which will give around 6-8 hp and runs around $300 i think
|
01-18-2005, 08:39 AM | #6 |
Registered User
Join Date: Apr 2002
Location: Winnipeg, MB
Age: 40
Posts: 3,821
|
thats it???^^ thats not much gains at all...
|
Thread Tools | |
Display Modes | |
|
|