.:HSTuners::

thermal · 12-20-2003, 08:31 PM

It's really simple. The hardest part is to get to that one bolt under the cushion which is located almost in middle but a little bit offset. It has a 12mm head. You do not have to take out the rear back rest. Once you get that one bolt out, pull the cushion out. There will be 2 clips on the front side. Unclip the wire connectors. Unclip the 2 tubings. Remove the cover. Replace the pump.....

12-20-2003, 08:31 PM	#3
thermal Banning Machine Join Date: Aug 2001 Location: My Garage, Va. Posts: 5,547	It's really simple. The hardest part is to get to that one bolt under the cushion which is located almost in middle but a little bit offset. It has a 12mm head. You do not have to take out the rear back rest. Once you get that one bolt out, pull the cushion out. There will be 2 clips on the front side. Unclip the wire connectors. Unclip the 2 tubings. Remove the cover. Replace the pump..... __________________ Project Teg Visit the Turbo Forum

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode