.:HSTuners::

11-01-2003, 08:32 AM

It's easy bro. I used a dremel w/tile cutting bit and some needle nose pliers. That orange piece is clipped in, but you can't get it out w/o cutting it. Start cutting it, being careful not to damage the edge of the bulb housing. Once you cut it down, get ur needle nose and pull out the pieces. After you get it all out, ur gonna need to spray out the tail light w/high pressure air hose to get all the shavings out.

Very easy, just takes a lil patience.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11-01-2003, 08:32 AM	#4
VRGNCD5 Posts: n/a	It's easy bro. I used a dremel w/tile cutting bit and some needle nose pliers. That orange piece is clipped in, but you can't get it out w/o cutting it. Start cutting it, being careful not to damage the edge of the bulb housing. Once you cut it down, get ur needle nose and pull out the pieces. After you get it all out, ur gonna need to spray out the tail light w/high pressure air hose to get all the shavings out. Very easy, just takes a lil patience.