.:HSTuners::

pimpinprelude · 06-22-2003, 10:20 PM

ok what u need to do to get that bolt off is... go to the local hardwhare store and get a torch.. nothing fancy it should be like 15-20$, and if u can dont get propane get mapp gas.. it burns soo much hotter! but if all thay have is pane get it.. carefully light it, and heat the bolt, and with a large hammer hit it ralllllly hard from the side.. that should snap it right off.. if space is tight get a long screw driver and put the pointy end on the blolt and hit it like that.. if that doesnt work. which i will be verry surprised if it doesnt.. get a hack saw and take the handle off so its just the blade, and put a LOT of motor oil on it (that redeces friction when u r cutting it).. and basicly cut it off.. ur arm will probably be numb when ur done.. but hey u will bw done! good luck..

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

06-22-2003, 10:20 PM	#8
pimpinprelude Registered User Join Date: Mar 2003 Location: Atlanta Age: 37 Posts: 1,325	ok what u need to do to get that bolt off is... go to the local hardwhare store and get a torch.. nothing fancy it should be like 15-20$, and if u can dont get propane get mapp gas.. it burns soo much hotter! but if all thay have is pane get it.. carefully light it, and heat the bolt, and with a large hammer hit it ralllllly hard from the side.. that should snap it right off.. if space is tight get a long screw driver and put the pointy end on the blolt and hit it like that.. if that doesnt work. which i will be verry surprised if it doesnt.. get a hack saw and take the handle off so its just the blade, and put a LOT of motor oil on it (that redeces friction when u r cutting it).. and basicly cut it off.. ur arm will probably be numb when ur done.. but hey u will bw done! good luck..