.:HSTuners::

09-15-2003, 09:25 PM

woudl this head gasket redce the d16y8's compression ratio? the d16a6 has a 9.1 and the d16y8 has a 9.6...so it seems as it would.

thanks

*AzCivic* · 09-15-2003, 10:48 PM

only by .2

so you'll go from 9.6 to 9.4

why do you wanna drop compression anyway? 9.6:1 isnt very high.

*pdiggitydogg* · 09-15-2003, 11:34 PM

^for boost

not much of a change...not really worth it. Get an aftermarket y8 gasket thats thicker if youre looking for a more significant drop

09-15-2003, 11:36 PM

Quote:

Originally posted by pdiggitydogg
^for boost

not much of a change...not really worth it. Get an aftermarket y8 gasket thats thicker if youre looking for a more significant drop

so expensive tho....i was gunna get a 3mm greddy one that was 300 bucks, but i wanna get my turbo on.

*AzCivic* · 09-16-2003, 11:12 PM

if you have a low displacement engine you don't wanna lower compression. the higher the compression the more low end power and less spool time. b16 and b18 have compressions of what? like 10.something :1 and they're fine w/ boost.

my advice would be to spend your money on MSD's little thing that retards timing under boost.

09-15-2003, 09:25 PM	#1
OPAKRACING Posts: n/a	D16a6 head gasket on a d16y8... woudl this head gasket redce the d16y8's compression ratio? the d16a6 has a 9.1 and the d16y8 has a 9.6...so it seems as it would. thanks

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-15-2003, 10:48 PM	#2
AzCivic Moderator Join Date: Feb 2002 Location: Az Age: 43 Posts: 3,804	only by .2 so you'll go from 9.6 to 9.4 why do you wanna drop compression anyway? 9.6:1 isnt very high.

09-15-2003, 11:34 PM	#3
pdiggitydogg Yahoo Watashi wa kattaze! Join Date: May 2002 Location: Meanwhile, up in The D... Age: 41 Posts: 10,579	^for boost not much of a change...not really worth it. Get an aftermarket y8 gasket thats thicker if youre looking for a more significant drop

09-16-2003, 11:12 PM	#5
AzCivic Moderator Join Date: Feb 2002 Location: Az Age: 43 Posts: 3,804	if you have a low displacement engine you don't wanna lower compression. the higher the compression the more low end power and less spool time. b16 and b18 have compressions of what? like 10.something :1 and they're fine w/ boost. my advice would be to spend your money on MSD's little thing that retards timing under boost.