.:HSTuners::

11-02-2002, 07:30 PM

i got a b16 engine swap just yesterday in my hatch and I want to go all motor I'am plannen on gettin a b20 block w/type r piston and of course the basics cams , pulley (ect..)just curious thump up or down????

*AzCivic* · 11-02-2002, 07:55 PM

I'd just resleeve the B16 with 84mm bore sleeves which will up your displacement a good bit.

slowEJ6 · 11-03-2002, 01:46 AM

eh....crvtec.
check 2ndGenTeg's post about alternatives to the LS/CRVtec motors....very good article.

*Addict* · 11-03-2002, 10:27 AM

http://www.hondastyle.com/forums/sho...&threadid=2259
Good reading....

11-02-2002, 07:30 PM	#1
dreg1320lab Posts: n/a	b20 block i got a b16 engine swap just yesterday in my hatch and I want to go all motor I'am plannen on gettin a b20 block w/type r piston and of course the basics cams , pulley (ect..)just curious thump up or down????

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-02-2002, 07:55 PM	#2
AzCivic Moderator Join Date: Feb 2002 Location: Az Age: 43 Posts: 3,804	I'd just resleeve the B16 with 84mm bore sleeves which will up your displacement a good bit.

11-03-2002, 01:46 AM	#3
slowEJ6 Registered User Join Date: Nov 2001 Location: Oviedo, FL Age: 42 Posts: 3,195	eh....crvtec. check 2ndGenTeg's post about alternatives to the LS/CRVtec motors....very good article.