.:HSTuners::::Hondas Wanted:: |
06-24-2003, 07:57 PM
|
#1 |
|
Posts: n/a
|
engine wont start??
ok I just gotten the head gasket changed on my car and also gotten the timing redone and when i tryed to start up my car it sounds like it wants to start but doesnt I was told this is an electricol problem has this happen to some one any suggestions?
|
|
|
06-25-2003, 01:00 AM
|
#2 |
|
1st Gear
Join Date: Dec 2002
Location: Illinois
Age: 44
Posts: 74
|
it ran before you changed the head gasket right? make sure your timing belt is on without a skipped tooth... a skipped tooth will still run but not too good... two skipped teeth however probably won't run... if you did something with the distributor, that's what you should check... pull out the spark plug wires and try to start the engine... your wires should arc if you put it near ground somewhere, if it doesn't then there's your problem... check your fuel too... bad fuel? clogged injectors? forgot to reconnect the injectors? could be so many possibilities...
__________________
Suja 1 Motoring 502 E St. Charles Carol Stream, IL 60188 630-407-0711 www.suja1.com AIM:Jazn671 |
|
|
|
06-25-2003, 01:32 AM
|
#3 |
|
Repost Wagon
Join Date: Dec 2001
Location: over here
Age: 44
Posts: 17,266
|
maybe you forgot to recconect something
__________________
 
|
|
|
|
|
06-25-2003, 04:22 AM
|
#4 |
|
Posts: n/a
|
ive been searchen and every thing seen's in place yeah the car ran befor i changed the head gasket because it over heated it has new spark plugs new spark plug wires just did the tune up it just wont turn on its seems like it gonna turn on but it doesnt
 |
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
