|
98 ACCORD AND UP
FIRST, YOU REMOVE BOTH OF THE HEAD LIGHTS, NEXT YOU GET YOURSELF A BLOWDRYER, HEAT UP THE SILICONE AROUND THE EDGES. (YOU SHOULD WEAR LATEX GLOVES, BECAUSE, YOU DONT WANT TO PUT FINGERPRINTS ON THE INSIDE OF THE LENS). REMOVE THE LENS FROM THE REST OF THE HOUSING. THE ORANGE STRIP SLIDES OUT. REVERSE THE STEPS TO RE-INSTALL. THE ONLY THING IS, WHEN YOU RE--INSTALL THEM, YOU WANT TO MAKE SURE YOU TAPE THE HOLES ON THE BACK WHERE THE BULBS GO. YOU DONT WANT ANY MOISTURE GETTING INSIDE. NEXT. YOU PROBABLY WILL WANT TO ADD SOME ADDITIONAL SILICONE. IF NOT, YOU CAN REPLACE ALL OF IT. IT WILL PROBABLY BE EASIER TO JUST SCRAPE OFF THE OLD SILICONE, AND GET YOU SOME NEW SILICONE. HERE'S THE SUCKY PART, YOU HAVE TO APPLY PRESSURE TO THE LENS AND THE HOUSING (PRESS THEM TOGETHER) FOR 20 - 25 MINUTES. UNLESS YOU HAVE SOME TYPE OF CUSHIONED CLAMPING DEVICE, OR A LITTLE BROTHER. I RECOMMEND THAT YOU HOLD IT LONGER THAN THAT. NO MORE THAN AN HOUR THOUGH. THIS IS TO ENSURE NO MOISTURE IS GONNA BE ABLE TO GET INSIDE. AFTER ALL OF THIS YOU WILL BE HAPPY, BECAUSE CLEAR HEAD LIGHTS COST ABOUT $200.00 A PIECE. GOOD LUCK
|