HSTuners - View Single Post

12-29-2001, 07:04 AM

Just to give you an idea heres what i got some of parts for

Spearco intecooler 28x10.5x3.5 $650 used but near new

Garrett 60-1 with a t3 turbine $750 from Majestic Turbo

SFP tubular manifold $450

3" downpipe $300

Turbonetics Racegate $338

piping and BOV were from my old DRAG kit expect to pay around
185 for the BOV and a good 3-400 for nice piping. Importparts.com will sell you piping kits but i doubt there is anything for the new Civics yet.

This will get you started. You will need some sort of fueling for the kit. It can be as simple as a Votech FMU which can be had form 180 bucks. The custom route can be had cheap or it can be very expensive. It all depends on what you want to do and what your goals are. If you are looking for jsut a street machine then the cost shouldnt be too bad. I would say it could be done for under 3K with a little bit of searching. Not everyone wants a 60-1 o that there alone will save you some loot. The hardest part will be finding a manifold and piping. You will need a downpipe but that is not too hard to make. My suggestion would bet to buy some used parts to save money if that is an issue.

12-29-2001, 07:04 AM	#10
Boosted3g Posts: n/a	Just to give you an idea heres what i got some of parts for Spearco intecooler 28x10.5x3.5 $650 used but near new Garrett 60-1 with a t3 turbine $750 from Majestic Turbo SFP tubular manifold $450 3" downpipe $300 Turbonetics Racegate $338 piping and BOV were from my old DRAG kit expect to pay around 185 for the BOV and a good 3-400 for nice piping. Importparts.com will sell you piping kits but i doubt there is anything for the new Civics yet. This will get you started. You will need some sort of fueling for the kit. It can be as simple as a Votech FMU which can be had form 180 bucks. The custom route can be had cheap or it can be very expensive. It all depends on what you want to do and what your goals are. If you are looking for jsut a street machine then the cost shouldnt be too bad. I would say it could be done for under 3K with a little bit of searching. Not everyone wants a 60-1 o that there alone will save you some loot. The hardest part will be finding a manifold and piping. You will need a downpipe but that is not too hard to make. My suggestion would bet to buy some used parts to save money if that is an issue.