View Single Post
Old 07-27-2003, 09:41 AM   #2
SUPERMAN
 
Posts: n/a
figured this out, it's simple.

first remove the two screws from the top of your guage cluster trim. these screws face upwards and are directly in front of the guages on the top of the trim.

second pry out the bottom of the trim. this piece just has some pins to hold it down in place.

remove trim piece.

you will notice two screws at the bottom of the cluster, one on each end. remove both, being careful not to drop them down into the dash. you will also have to remove a third screw that is in the top of the cluster, dead center.

now you can pull out the guage cluster, you will find the wiring harness plugged into the top, behind of the cluster, this will have to be upplugged.

the cluster itself is held together with just plastic clips, remove those and do whatever you needed to do with the cluster. I installed a i-vtec indicator light.


SUPERMAN
  Reply With Quote