Just had Car Dynoed!!!
 

I just got my car dynoed with a Superflow chassis Dyno at Bottle Blown Racing in Camarillo, CA and was suprised to see the numbers I pulled. Between 7917-8096 RPM's I had a CWhlPw CHp of 180.0-180.4 and pulling torque figures between those rpm's from 116.8-119.5. Max torque was at 6260/6297 rpm's at 126.7 CWhlTq Clb-ft. My current setup is as follows:
JDM B18C ITR engine
JDM 4-1 exhaust manifold (2.5 inch)
AEM Cold Air Intake
Hollowed Out CAT
Greddy SP Exhaust
P73 ECU.

I was pretty impressed with what numbers I had. What do you think?

coooooooooool beeeeeeeeeaaaaaaans :yes:

lol nice....i gota get mine dyoed after i install some stuff i bought....still need my dang headers..

hey thanks, oh I forgot to mention, maybe this will make a difference, doubt it, I replaced the blue ngk wires for some magnecor wires (red) and then I ran the dyno.

Looks nice and its putting out some nice numbers. Congrats

It sounds sick... keep up the work man! AAARRRRRRRRRRRRR!!!

Pretty impressive numbers. I didn't think you could get that much power to the ground with so few mods. You wouldn't happen to have the chart would you? I'm curious where your power band is(even though you mentioned peak power/rpm). Also, how much does your car weigh? Thanks.

Very nice my man...keep up the nice work and impressive #'s...

The link listed below is to my album of pictures with some other cars in there. The dyno sheet is all the way in the bottom.

http://www.imagestation.com/album/?id=4291577121

it is all on page 6 in the link I listed above

What the Heck is the Redline at in your Engine!?!?!
8k seems a bit high...

BUT Dang...
:bow:

i just read your sig....a JDM B18CR motor....comes stock with what? 205fhp?
judging by that with your current mods - the whp sounds average.

not really most people with those mods are only running 170 to the wheels.

oh yeah, redline is at 8600 rpm