Had an accident
 

:mad: I was in a accident recently where I rear ended another car. Theur car had a broken tailight while mine was in pieces. I had also removed collision on my car a week before to save money so I'm f**&#@. I can do all the work myself but I need a new radiator support, and don't know how to take off the old one and weld the new one back on. If anyone has any suggestions let me know. I am also replacing my cylinder head at the same time and was wondering how hard is it and what is involved.

Peace

rad support is bolt on (98% positive)

if youre doing the same head its straight forward, but unless you know what youre doing to check timing and what-not you might as well take it somewhere

Thanks, do you know what kind of welds its held on by, should i drill them out?

edit**
my bad...yes it is welded
"yup....there are small tack welds all over..."

I was just looking at the support theres are no bolts at all and is is welded staight onto the frame. I'm worried about how to get the thing off.

reciprocating saw
air chisel
air grinder
(i did retract my previous statement)