D16Z6 Turbo
 

Ok I've been searching and my eyes hurt so here it goes, I'm looking at a '94 Del Sol Si (D16Z6) and I want to run 12.5-13.0 on it. What's the turbo kit to go with? Where are reviews? I want to do it on stock internals too.

heh i doubt that you could run with a turbo on stock internals those times. i think you need to boost at least 15psi to get to those times and a civic engine will take up to 8-9 on stock internals

Ok what ET/HP/TQ will I yield with an intercooled GReddy kit at 10-12 pounds? What supporting mods will I need to run 10-12 PSI?

I have a D16Z6 turbo running 12psi with far from stock internals. I tried running it on stock internals and it lasted about 3 months before the pistons fell apart, the rings toasted and the head gasket went south.

I am now running the following..

Arias forged pistons
Total seal rings
ARP head studs
Greddy 2mm head gasket
RC injectors
BBK Fuel pump
aem fuel rail
jackson racing rising rate fuel pressure regulator
custom short runner intake manifold
ApexI VAFC
Greddy intercooler, yeah the big one
APEXi blow off valve
excedy stage II clutch with lightened flywheel
big bore throttle body
greddy turbo timer
aem high flow fuel filter

there is more but I can't quite remember right now. There are also a few of my own personal touches. It has also been tuned on a dyno.

247hp
best et.. 12.7 @ 107

oh yeah, I almost forgot the following

B&M oil cooler
Fluidyne Radiator
low temp thermostat and fan switch
dual fans
custom downpipe
2.5" cat back exhaust with catco highflow cat

Damn you!!!
I want all that!!!
I never knew your actual set up. NIce....!!!

No you don't, high power equals high maintenance. I'm having some serious timing and vacuum issues right now. Car barely does 60mph. I'm replacing the coil today and all the vacuum lines. Also I think my coolant temp sensor is causing the car to run way too rich. Hopefully she will be back on the road in full force tonight.