Bright license plate
 

How do ppl make their license plate really bright to where u cant see it. It almost looks like a strobe.

its illiegal

Yeah, you'll get pulled over for it a lot if its too obvious. Not really worth it.

you cant put a switch on it???

you can put a switch on any type of light you just gotta buy the switch.

be careful though, dont get pulled over ;)

i want to know how to do it. I know how to put something on a switch

measure out the wire that will go to the power source (usually the red one, you may have to extend it by adding more wire to it).
example if you attach the wire to the battery; place the wire near the battery and stretch it out to the license plate.
get your switch and find where youd like to mount it. clip the wire in two; somewhere near the switch.
the switch will have two little metal pieces on the bottom; attach one of the wires to one of them and the other wire to the other one. then just attach the wire to the power source and figure out what position the switch has to be in for the light to turn on.

ill try and post pics of how i did my strobe switch and the switch for the power inverter, so you can get a better idea cuz i suck with describing directions
:o

oh cr*p
nevermind the above post
i had it backwards

:doh: :yuck:

i meant that i knew how to hook up a switch what do ppl put in or by their plate to make it so bright or to were u cant see it?

hahaha whats the point of even putting a switch on, by the time you think to turn it off the cops will have already lit your ass up....


dont do it unless you wanna get pulled over all the time (well at least around here in the DC area)

I have everything on a switch i just dont go rolling around with my street glow on it is only for show or a parked situation. I want to know how to do it not if it is illegal or when i should and shouldnt have it on